[Alec]

Someone connected jumper leads the wrong way around and blew a 150A Fusible Link on my 2009 CW. RAC bypassed it.
Where do I go to get a replacement, and is it just a case of screwing it in? I can't find anything online.

[The Gonz]

5Pcs Fuse 150A AMP AFS Small Wafer Style Fuse 32V For Audio/Car/RV/Boat Stereo B | eBay

Undo the screws, place the link in, retighten. Or you could try just about any auto electrician and ask for a piece of 150A fusible wire and do what the RAC did.

[mickd]

" someone " ??   
Did the same to my bike last week        

[tw2005]

18980-05932  MIDIFUSE (AMI)150A

The 12 Volt Shop

Could just hit the wreckers, not something you'd expect to hunt or any decent auto sparky



153.5631.6151 | Pudenz 150A Grey BF1 Automotive Bolt-down Fuse, 32V dc | Pudenz

check the dimensions of original

[tw2005]

Narva 53915 ANL Copper Alloy Fuse 150Amp



I'm thinking this is too big.

[tw2005]

2 pack Blue Sea 5258 AMI® MIDI® Fuse 150 amp Marine, 4x4, 4WD, Caravan Motorhome 632085052584 | eBay

WA seller

[beerman]

That someone, they are a bit of a worry, hangs around my kids a bit.....

[Alec]

Thanks all, super helpful.

And it honestly wasn't me!

[nzenigma]

That someone, they are a bit of a worry, hangs around my kids a bit.....

  well put 

[Anthony]

u buy the replacements at your automotive shop and yes you do need to unscrew it to get tbe old fusible link out and after u put the new link in test it first and then make sure u have tightened up the phillipes head screws  am glad to help

[Alec]

u buy the replacements at your automotive shop and yes you do need to unscrew it to get tbe old fusible link out and after u put the new link in test it first and then make sure u have tightened up the phillipes head screws  am glad to help

Thanks
How do I test it? Get someone who is not me to put jumper leads on the wrong way?

[The Gonz]

Testing is to run the car normally. If everything works, the fuse is OK. Easier than probing each end with a multimeter for continuity. Keep it simple and just make sure the screw connections are tight.