[Dazzler]

Yeah they work! Well done. Interestingly they actually look like a satin finish to me. 

[CraigB]

After much deliberation a friend of mine hooked me up with these.
Should be on next week

They'll do the trick

[mshk99]

They look good!

I think a set of gloss black mirror covers will complete the look to match the tints.

[CraigB]

They look good!

I think a set of gloss black mirror covers will complete the look to match the tints.

Personally I think black mirrors on a coloured car make them look unfinished, like someone forgot to paint them

Those wheels also look like a Satin finish to me as well which don't look tacky like gloss accessories do.

[Dazzler]

They look good!

I think a set of gloss black mirror covers will complete the look to match the tints.

Personally I think black mirrors on a coloured car make them look unfinished, like someone forgot to paint them

Those wheels also look like a Satin finish to me as well which don't look tacky like gloss accessories do.

I can see both points of view on this. On a wite non prem SR I think gloss black mirrors might look pretty good.  Not so much on my red one maybe.   

[mshk99]

I have a white one so this is what it looks like from side and front. I guess I'm going for a 'Panda Spec'

can't wait to see how the ROHs go

[Dazzler]

Cool! that works...

[andrich]

New shoes are on. Pretty happy with them

[andrich]

And a debadge while I'm at.
Adds to the clean look I reckon

[Purplehazeffc]

And a debadge while I'm at.
Adds to the clean look I reckon

100% agree on the de-badge.   Now to paint the rear Hyundai badge Black..  As it can't be removed as there is a cpl of holes behind..
The rims look great..    Do you know if they are any lighter than the standard 18's ????

How have you gone so far with your intake??

[andrich]

cheers mate,
Yeh that was the plan, did you just plastidip it?
did you take it off or mask it up?

Yeh the intake is going well.
A little loud on part throttle but sounds good when giving it a hit.
Did you fit the heat shield? i havent looked at mine yet
cheers

[CraigB]

That's the benefit of Plasti Dip, you don't have to remove anything sheet off the rear of the car leaving a hole for the badge - give it 3 to 5 coats and when done peel off the sections in between the badge and any over sprayed areas.


Autobarn sell the genuine Plastidip, it's better than the imitation stuff from Supercheap.

[Purplehazeffc]

cheers mate,
Yeh that was the plan, did you just plastidip it?
did you take it off or mask it up?

Yeh the intake is going well.
A little loud on part throttle but sounds good when giving it a hit.
Did you fit the heat shield? i havent looked at mine yet
cheers

Yeah I took my badge off to paint it. Using this Aerosol Paint - Acrylic, Satin Black, 400g | Supercheap Auto
Just using a heat gun & a plastic type credit card works wonders..

But as Craig mentioned above. Plastidip will also work as well..     Whatever you would find easier..

Yeah I have the heat shield fitted. Must say it does look pretty good & tidies up the engine bay. And the sound is also quite good..
Iv'e put some photos up in this thread: Fitted: TORCON One Bend Aluminium Intake SR Turbo

PD SR Stereo Install. Speaker, Amps, Subwoofer