[chrisrounce]

Does anyone know how to replace a screen washer jet, passenger side is fine but the drivers side has pressure ok but spray pattern has gone low

[eye30]

Do you just mean the nozzle?

Is it blocked?

If so then you can either use a fine pin to clear or open bonnet, find where the tube from the bottle joins, separate and blow air though to clear.

Otherwise to remove on my fd and gd they just pull away/out from their seating.

[Lorian]

and if you mean its pointing low stick a needle in it and pull upwards a bit.

[eye30]

@chrisrounce

Any update?

[mickd]

@chrisrounce

Any update?

Been busy ?? 

[chrisrounce]

I had to purchase a new jet from Hyundai as all on ebay were to small to fit into the plastic top moulding

[eye30]

I had to purchase a new jet from Hyundai as all on ebay were to small to fit into the plastic top moulding

Result and a relative cheap fix.

[Spongey]

Sorry to revive an old topic, have the same issue our 13 plate I30, tried clearing with a pin, and blowing the system through both from the pump and the jet with the compressor but the spray pattern has gone on the driver's side so need to replace. Did the spray nozzle just pull out from the plastic scuttle panel? Started trying this morning but backed away when it wouldn't budge.
Thanks, Dave

[Spongey]

No need to reply.... Went back out and had another go using a stiff wallpaper scraper and it popped out, bit more bravery needed.
Thanks all,
Dave

[Lorian]

you sure you cant just clean it?